If you do not receive any output, like in the image below, it is an indication that the system is not identifying any RAID controller. LSI Logic / Symbios Logic MegaRAID SAS 1078 (rev 04) output 2Ġ1:00.0 RAID bus controller: Adaptec AAC-RAID (rev 09) output 3Ġ2:00.0 RAID bus controller: LSI Logic / Symbios Logic MegaRAID SAS 2208 (rev 05) The output will display your RAID controller. Use the lspci command to verify the RAID controller on your system. If you are unsure which RAID controller you are using, start by verifying it. To use MegaCLI, you need a MegaRAID SAS controller. Step 1: Verify Your Hardware RAID Controller This article provides instructions on installing MegaCLI on CentOS 8 and Ubuntu. MegaCLI supports MS Windows, FreeBSD, Solaris and all major Linux distributions. Access to the command-line/terminal window.A Linux system (installation instructions apply to CentOS/RHEL and Ubuntu based distros).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |